Pairing Additional Receivers to the Remote
You can install more than one remote control receiver to control
additional sets of speakers. You can then pair and control up to
3 receivers with 1 remote control.
NOTE: The remote is paired at the factory with the included
receiver as group 1.
1
Disconnect power from the receiver you want to pair with the
remote.
2
Reconnect power to the receiver.
3
Within 6 seconds, hold for at least 2 seconds the group
number (1, 2, 3) to assign to the receiver.
The light in the center of the color wheel flashes 3 times to
indicate a successful pairing.
4
Release the group number to complete the pairing.
Disconnecting a Receiver Group from the Remote
If you no longer want to control a remote control receiver you
paired to a remote control, you can disconnect the group
number on the remote from the paired receiver.
1
Disconnect power from the receiver you want to disconnect
from the remote.
2
Reconnect power to the receiver.
3
Within 6 seconds, hold for at least 2 seconds the group
number on the remote (1, 2, or 3) to disconnect the receiver.
The light in the center of the color wheel flashes 9 times to
indicate a successful disconnection.
4
Release the group number to complete the disconnection
process.
Specifications
Input voltage 10.8 to 16 Vdc
Fuse 7.5 A
Max. capacity Up to 8 RGB LED speakers (4 pair)
Operating temperature 0 to 50°C (32 to 122°F)
Storage temperature -20 to 70°C (-4 to 158°F)
Battery type 2 AAA (not included)
Radio frequency 2.4 GHz @ 10 dBm nominal
Range Up to 10 m (30 ft.)
Water resistance Remote control receiver and remote control are
not water or dust resistant.
Registering Your Wireless RGB LED Remote Control
Help us better support you by completing our online registration
today.
• Go to www.fusionentertainment.com.
• Keep the original sales receipt, or a photocopy, in a safe
place.
4 Installation Instructions
To Next Page
Loading...
Need help?
General
