Part 1382606 Rev 2 (12/07) Page 7
OPERATION
Filter Quick
IMPORTANT: never operate the lter unless the fryers
have been brought up to a cooking temperature, and lter
heater has been turned on for at least 30 minutes.
The Filter Quick System revolves around two original
inventions – one, the Power shower that snaps into the
frypot and – two, the self-aligning lter holder that can be
lifted out and cleaned easily.
1. Shut down Fryer by rotating thermostat dial clockwise.
2. Snap power shower into frypot connection. The inlet tube
on the Power shower snaps into a tting in the frypot.
3. Open Drain Valve. Drain valve safety switch will turn Fryer
o if operator forgets.
4. Pull lter lever to start lter pump., clean ltered fat
is pumped to the Power shower. A carefully designed
shower pattern directs jets of hot fat down over every
inch of the frypot. Crumbs and sediment are ushed o
sides and splash area into the ltering system.
5. After shorting is completely ltered, close drain valve,
allow fryer to ll before disengaging the lter level to turn
o the lter pump.
6. Remove power shower assembly
7. Set Temperature to start cooking
The entire ltering operation is automatic and usually
requires only three (3) minutes in the 35 lbs fryer. The
operator does not have to handle a hot hose, which can
be dangerous, or change a hot lter. Employees are free to
do other tasks while ltering is in progress. As many as six
35 lb GARLAND gas fryers may be batteried together and
manifolded to a single Filter Quick System. One fryer may
be ltered while others are still in use. As each is ltered and
relled, the next fryer can be ltered by moving the Power
shower and repeating the operation.
Changing Filter
1. Removing the lter holder is accomplished by gently
pulling the insulated handle on the lter holder towards
you, disconnecting the lter from the pump and pulling
the caster-mounted drain drawer out of the cabinet
2. Once you have disconnected the lter, you are now ready
to pull out the drain pan and remove the crumb screen.
3. Remove the dirty lter paper and replace with clean new
paper. The dirty lter paper can be removed, its holder
cleaned and clean lter paper and lter powder installed
– all in a slack time period. Use extreme caution not
to contaminate the lter holder with sediment when
removing the dirty lter paper.
4. Push the drawer back into place. The self-aligning slip
connection is made to the pump and the system is ready
for use. The complete change is made in less than a
minute.
The Filter Quick system saves fat, labor costs and makes a
formerly hard job easy
To Next Page
Loading...
Need help?
General