GE 14 Use And Installation Guide

The temperature control dial has nine settings plus
“OFF”. “1” is the warmest. “9” is the coldest. At
first, set the dial at “5.” After using the refrigerator,
adjust the dial if necessary.
Insert a coin into the slot in the middle of the dial and
you can turn the dial to the setting that’s best suited to
your needs.
Allow 24 hours for the refrigerator to get cold.
NOTE: Turning the dial to “OFF” stops cooling in
both compartments—fresh food and freezer.
5
1
7
9
3
OFF
TEMPERATURE CONTROL DIAL
4
FRESH FOOD COMPARTMENT SHELVES
Shelf supports at various levels allow you to custom-space shelves.
Half-Width Shelves (on some models)
One end of the shelf
rests on a molded
side-wall support; a
bracket on the other
end hooks into a
track on the rear
cabinet wall.
To remove, lift the
shelf up at front, then
off the support and
out of the track.
To replace, select desired shelf height. With shelf
front raised slightly, hook the bracket’s top lug into
the track, then lower the shelf onto the support.
NOTE: The shelf to the right of
the track is designed to hook into
the right-hand slot; the shelf to the
left is designed to hook into the left-
hand slot.
2
Lift up
and out
1
Tilt up
Full-Width Shelves (on some models)
Some models have a steel wire sliding shelf, a
stationary tempered glass shelf or two steel wire
stationary shelves. These shelves can be moved to
another place in the fresh food compartment.
The full-width sliding shelf has
stop-locks. When placed
correctly on the shelf supports,
the shelf will stop before
coming completely out of the
refrigerator and will not tilt
when you place food on it or
remove food from it.
To remove the
full-width shelves.
Lift the rear of the
shelf and pull
forward.
To remove a full-
width shelf when
the fresh food
compartment
door cannot be
opened fully…
lift the rear of the
shelf, pull forward
and down, tilt the
shelf and take it out.

GE 14 Specifications

General

Brand	GE
Model	14
Category	Refrigerator
Language	English