2
Safety Rules
READ AND SAVE THESE INSTRUCTIONS
WARNING: To reduce the risk
of personal injury, do not bend
the blade arms (also referred
to as fi anges), when installing
the brackets, balancing the
blades or cleaning the fan. Do
not insert foreign objects in-
between rotating fan blades.
WARNING: To reduce the risk of
fire, electric shock or personal
injury, mount to outlet box
marked “acceptable for fan
support of 15.9 kg (35 lb.) or
less” and use mounting screws
provided with the outlet box.
Most outlet boxes commonly
used for the support of light
fixtures are not acceptable for
fan support and may need to be
replaced. Due to the complexity
of the installation of this fan, a
qualified licensed electrician is
strongly recommended.
Min. 7ft/2.13m
Min. 30in/76cm
1. To reduce the risk of electric shock, ensure electricity has
been turned off at the circuit breaker or fuse box before
beginning.
2.
All electrical connections must be made in accordance
with local codes, ordinances and/or the National Electric
Code. Electrical installation should be performed by a
qualified licensed electrician.
4. CAUTION: To reduce the risk of personal injury, use only
the screws provided with the outlet box.
5.
The weight of the fan is 7.4 kg (16.31 lb). The outlet box and
support structure must be securely mounted and capable of
reliably supporting a minimum of 15.9 kg (35 lb.). Use only
UL Listed outlet boxes marked “FOR FAN SUPPORT.”
7. Avoid placing objects in the path of the blades.
8. To avoid personal injury or damage to the fan and other
items, be cautious when working around or cleaning the fan.
9. Do not use water or detergents when cleaning the fan or
fan blades. A dry dust cloth or lightly damped cloth will be
suitable for cleaning.
10. After making electrical connections, spliced conductors
should be turned upward and pushed carefully up into
the outlet box. The wires should be spread apart with
the grounded conductor and the equipment-grounding
conductor on one side of the outlet box and ungrounded
conductor on the other side of the outlet box.
11. All screws must be checked and re-tightened where
necessary during installation.
3.
WARNING: To reduce the risk of fire, electric shock or
personal injury, do not use this fan with any solid state fan
speed control device, or variable speed control.
12. This fan is designed to be mounted on a flat ceiling only.
Do not mount fan on a sloped or vaulted ceiling.
6. The fan must be mounted with a minimum of 2.13 m (7 ft.)
from the floor and 76 cm (30 in.) from any wall or obstruction.
This fan is suitable for room sizes up to 20.9 square metres (225
square feet).
To Next Page
Loading...
Need help?
General
