GE 24922 User Manual

12
Using Your Remote, cont.
3. Press and release the MUTE button.
4. Press and release the VOL - button.
The red indicator light will blink twice
and go off.
Code Identification
1. Press and hold the SETUP button
until the red indicator stays on
(approximately2seconds)andthen
release the button.
2. Press and release the desired device
button (TV, DVR, CBL, B-RAY, AMP,
AUX) you would like the code for.
3. Press and release ENTER button.
4. Press and release the #1 button.
Count the number of times the
remote light flashes. This is the
number corresponding to the first
digit of the code. Repeat the process
by pressing the #2, #3 and #4
buttons for the remaining digits.
5. Press and release ENTER button to
exitthismode.
Reset to Factory Settings
1. Press and hold the SETUP button
until the red indicator stays on
(approximately2seconds)andthen
release the button.
2. Press and release the MUTE button.
3. Press and release the number #0
button. The red indicator light will
flash twice.

GE 24922 Specifications

General

Brand	GE
Model	24922
Category	Universal Remote
Language	English