GE 24922 User Manual

8
Programming Your Remote, cont.
Auto Code Search
The Auto Code Search, searches automatically
through all of the codes stored in this remote. Read
all the following steps prior to starting the auto code
search as you will need to be prepared to lock-in the
proper code when found.
1. Manually turn on the device you wish
to control.
2. Press and hold the SETUP button
until the red indicator light stays on
(approximately2seconds)andthen
release the button.
3. Press and release the device button on
the remote (TV, DVR, CBL, B-RAY, AMP,
AUX) for device you wish to control.
The red indicator will blink once and
then remain on.
4. Point the remote at the device and
press and release the POWER button
(for TV) or PLAY button (for DVD, VCR,
etc.) to start the search. The red
indicatorwillash(approximately
every 2 seconds) as the remote
searches. Note: The remote must be
pointed at the device for the duration
of this search.
5. Place your finger on the #1 button so
you are prepared to lock-in the code.
6. When the device shuts off or begins
playing, press the #1 button to lock-in
the code. The red indicator light will
turn off. Note: You have approximately
two seconds after the device shuts off
or begins playing to lock-in the code.
7. Point the remote at the device and
check to see if the remote operates the
device as desired. If it does, no further
programming is required for that
device. If it does not, return to step 2
and start the auto code
search again.

GE 24922 Specifications

General

Brand	GE
Model	24922
Category	Universal Remote
Language	English