1
Setting The Incoming Message Time
This setting allows you to select the length of the incoming message.
This menu comes when you have nished setting the Rings to Answer.
1. The answering system announces “Message Time (current message length)
minutes. To set message time, press next, press set to continue.”
2. To change the message length, press and release the NEXT or PREVIOUS button
and the answering system announces a number, such as “1,2,3,4.”
3. After choosing a number, press and release the STOP/SET button to store the
message time. The answering system enters Security Code Menu.
Setting the Security Code
This setting allows to change the factory default security code used to access your
answering system from a remote location. This menu comes after you have nished
setting the Incoming Message Time. The default code is 123.
1. The answering system announces, “Security code (the current 3 number Security
Code setting). To set security code, press next...press set to stop.”
2. If you press and release the STOP/SET button, the answering system announces all
the new settings and exit the set up menu.
3. If you press and release NEXT or PREVIOUS button, answering system announces
“Security Code (current 3 number). To set security code, press next, press set to
continue”.
4. To change the rst security code number, press and release the NEXT or PREVIOUS
button again. The answering system announces all three numbers, but only the
rst number will change, such as “123, 223,” or “123, 023”.
5. After choosing the rst number, press and release the STOP/SET button to store the
rst number.
To Next Page
Loading...
Need help?
General
