toc-2 345 TRANSFORMER PROTECTION SYSTEM – QUICKSTART GUIDE
Hardware and software requirements 46
Installing the EnerVista SR3 Setup software 46
Upgrading the software 49
Connecting EnerVista SR3 Setup to the relay .......................................................... 49
Configuring serial communications 49
Using the Quick Connect feature 50
Configuring Ethernet communications 51
Connecting to the relay 52
Working with setpoints and setpoint files ................................................................... 53
Engaging a device 53
Entering setpoints 53
File support 54
Using setpoints files 54
Downloading and saving setpoint files 55
Adding setpoints files to the environment 55
Creating a new setpoint file 56
Upgrading setpoint files to a new revision 57
Printing setpoints and actual values 58
Printing actual values from a connected device 59
Loading setpoints from a file 60
Uninstalling files and clearing data 60
Upgrading relay firmware .................................................................................................. 60
Loading new relay firmware 61
Advanced EnerVista SR3 Setup features ..................................................................... 62
Flexcurve editor 62
Transient recorder (Waveform capture) 63
Protection summary 66
QUICK SETUP -
FRONT CONTROL
PANEL
Quick Setup menu ............................................................................................................71
MAINTENANCE General maintenance .....................................................................................................75
In-service maintenance ....................................................................................................... 75
Out-of-service maintenance ............................................................................................. 75
Unscheduled maintenance (system interruption) ................................................... 76
To Next Page
Loading...
Need help?
General
