Otherfeaturesof yourZoneline.
On/Off Switch
The unit on/oH' switch is located on the ti'ont oI
the Zoneline.
Toturn the unit on, press the top oI the switch in.
Toturn the unit of[, press the botton_ oI the
switch in.
ON/OFF
switch
Ventilation Control
The ventilation control lever is located on the
left side ot the Zoneline unit, behind the ti'ont
case panel.
To access the ventilation control leve_; remove
the front panel by removing the filte_; taking out
the ti)m" ti'ont screws, the ul)per two screws ti'om
the top of the panel and the shipi)ing screws on
each side, if present. (Discard the two side
shipi)ing screws, if present).
_._]_en the lever is in the CLOSEposition, only the
air inside the room is circulated and filtered.
\._]]en the lever is in the OPEIVposition, some
outdoor air will be drawn into the room. This
will reduce the heating or cooling eflidencv.
Toclose the vent, push the vent lever handle
down, pull it fin'ward and lock it up in place.
Toopen the vent, push the vent lever handle down,
push it back and lock it up in place.
0
Ventcontrol
(pushleverdown
andpullforward
orbackto
operate)
Energy Tip: Kee I) the vent control in the
CLOSEposition. The room air will be filtered
and drculated.
AboutHeat Pumps(onsomemodels)
Heat pumps can reduce operating costs by
exchanging heat ti'om the outside air----even
when the outside temperature is below
fl'eezing-- and releasing that heat ind{){n_.
To get the best economic benefit ti'om yore" heat
I)ump, don't change the room themmstnt setting
very often. Raising the heat setting 2-3 degrees
will cause the Zoneline to use its electric heating
elements in order to reach the new temperature
setting quickly.
There is a three minute minimum compressor
mn time at any setting to prevent short cycling.
The indoor tim motor stnrts befin'e the
compressor and stops after the compressor
cycles off.
The electric heating elements use much
more electricity than heat i)umps and cost
II/OI'e to operate.
8
To Next Page
Need help?
General
