GE DDG7580G User Manual

PROBLEM
SHWNKAGE,
KNITS
WMNKLINGIN
PERMANENT PRESS
AND “NO-IRON”
ITEMS
POSSIBLE CAUSE AND REMEDY
● Rela~tion shrin~ge can occur in hit fabrics that have been improperly stretchd
and eiongatedby the manufacturer. When this occurs, garment maybe pressed back into
shape after each wash and dry cycle.
● ~ogressive or delayed shrinkage is caused when starch or sizing (in some hbrics) is
gradudly removal by laundering. Maybe noticed in older garments that have been
laundered many times without previous
s-e. T~t as for Re-on S- me.
. Shrinkage caused by overheating occurs in certain knit fabrics that have b=n heat-
shaped. When washing, drying or ironing temperatures exceed tie temperatures used to
shape set, shrinkage may occur. This cannot be corrected, but it can be prevented by
washing in cold or warm water; drying on low heat.
● Leaving clothes in dryer after tumbling stops. Remove clothes promptly and hang
them immediately.
. Too many items in dryer. Dry only one washer load at a time. Do not combine loads.
● Too few items in dryer. If drying only one article, add two or more similar articles, even
if dry, to insure proper tumbling.
Q Improper loads. Avoid laundering heavy Permanent Press items, such as work clothes,
with lighter Permanent Press items, such as shirts or blouses. Do not wash or dry
Permanent Press with regular laundry.
● Too many clothes in washer. Items must have room to move freely. Permanent Press
loads should always be smaller than regular loads..
.no more than medium loads.
● Use of incorrect wash and dry cycles. Use Permanent Press Wash Cycle which provides
a cool-down rinse to minimize
wrin~ing. Also, use Permanent Press Dry Cycle.
● Inco~ect water level. Use large water level for medium load; medium level orhdf fill
for small load.
● Washing repeatedly in too hot water. Wash in cool or
warm water with plenty of detergent.
11

GE DDG7580G Specifications

General

Brand	GE
Model	DDG7580G
Category	Dryer
Language	English