~Fabric
Care Selections
Push a button to select the proper heat for your load.
Should be used with cycles indicated ●
Automatic,
Fabric Care
Automatic
Perm Press and
Timed
Selections
Regular Cycle
Knits Cycles
Cycles
Cottons
High
Heat
●
●
Perm
Press
Medium Heat
●
●
Knits/Delicates
Low Heat
●
●
Fluff
No Heat
●
@Extra Care Cycle
(Operates only with Automatic,
Perm Press& Knits Cycles.)
Turn to ON if desired. To minimize
wrin~es
set in the clothes, the Extra
Care cycle provides approximately
15 minutes of no-heat tumbling
after the clothes are dry.
Use End-of-Cycle Signal. Signal
will sound at five-minute intervals
to remind you to remove the clothes.
@
Select End of Cycle Signal, if
desired. (See below.)
~
Turn Cycle Selector to desired
cycle setting. The selector may be
turned in either direction.
~
Press PUSH
~
START button
to start dryer. (Opening the door
during operation stops the dryer. To
re-start,
close the door and press
the START button. )
End-of-Cycle Signal
(Operates with any cycle. )
The Signal control can be set
anywhere between OFF and
LOUD, depending on desired
sound level. The signal
will
sound
just before the end of the cycle to
remind you to remove the clothes.
To stop signal while sounding, turn
Signal control to OFF or advance
Cycle Selector to OFF.
The Signal should always be used
when drying Polyester Knits or
Permanent Press items which
should be removed as soon as the
dryer stops to help prevent setting
of
wrin~es.
The signal should
also be used with
the Extra Care Cycle.
Polyester Knik &
Permanent Press
drying tips
●
DO NOT
OVERLOAD—
Garments being dried or
dewrin~ed
should tumble freely.
●
REMOVE
CL~HES
PROM~LY—To
help prevent
wrinkling, remove from the dryer
promptly at the end of the drying
cycles.
●
PLACE ON
HANGERS—
Permanent Press and Polyester
Knit garments look best if placed
on hangers after drying.
5
What is the difference
between
~med
&
Automatic drying?
Timed Drying
When using the TIMED CYCLES,
you select the number of minutes
you wish the dryer to run and it
turns off at the end of this time
period.
Automatic Drying
When using the Automatic Cycles,
the
Electronic Sensor Control
system
continually senses the
moisture in the tumbling clothes,
determines when they are dried to
your pre-selected setting, and
terminates the cycle automatically.
Refer to the CONTROLS SETTING
GUIDE for recommended settings.
The Cycle Selector will not advance
until clothes have reached a certain
degree of dryness.
Dryness selections guide for
the automatic cycles
Set to Middle Position
,,,,
0.”
M-,
-
m“
/
(Q
,+.:&.
~,-+.
●
For most normal loads.
Set toward MORE DRY
,[ss
..”
. For loads that include heavy-
weight fabrics.
●
If you desire to remove more
moisture.
Set toward LESS DRY
●
For lightweight fabric loads.
●
If you desire to remove less
moisture.
●
For very small loads.
To Next Page
Loading...
Need help?
General
