GE GEP-09CA User Manual

• Exhaust
Nozzle (1)
• Exhaust
Hose (1)
• Hose Connector
(1)
• Flat Screws (2)
1 for extension panels
1 for nozzle
•
Remote Control
LOCATION REQUIREMENTS
• Place the air conditioner on a flat level surface in a
location that is at least 51 cm from any wall.
NOTE: A minimum clearance of 51 cm from the air
conditioner to the wall must be maintained to ensure
proper airflow
• Maintain a minimum 51 cm clearance around the air
conditioner to not block airflow
• Keep the air conditioner free of any obstructions such as
drapes, curtains, blinds, etc.
• The exhaust hose should be free of any obstructions.
• Do not place the air conditioner on an unstable or raised
surface because it could fall and cause damage or injury.
• Do not place the air conditioner in direct sunlight or near
a heat source such as baseboard heaters, stoves, etc.
• The window panel can be installed in a window with a
minimum 51 cm to a maximum 101.6 cm opening.
(51 cm)
(51 cm)
ELECTRICAL REQUIREMENTS
POWER SUPPLY CORD
Wiring Requirements
• 220 Volt, 50Hz, 16-amp fused grounded outlet
• The use of a time-delay fuse or time-delay circuit breaker
is recommended.
• Use a dedicated circuit only.
NOTE: Do not operate any other electrical
appliances on this circuit or you may trip the circuit
breaker/fuse.
If this power supply cord is damaged, it cannot be repaired. It
must be replaced with a cord from the product manufacturer.
4
ENGLISH
WARNING
Electrical Shock Hazard
Plug into a grounded outlet only.
Do not remove the ground contacts from the power
cord plug.
Do not use an adapter
.
Do not use an extension cord.
Ïäìïøõè÷o followthese instructions can result in death,
fire òõèïèæ÷õìæäï shock.

GE GEP-09CA Specifications