5
Installation
How to install
Install refrigerator in a convenient location away from
extreme heat and cold.
(Green/yellow color wire located at the lower left portion
at the back of the refrigerator) to any metal pipe or to a
cover screw of the wall receptacle or to a rod buried at
least 2.4 meters. in the ground.
INSTALLATION
1.
•
Allow sufficient clearance between the refrigerator’s
back, also the side wall, so the door can open fully and
to minimize noise. This refrigerator is not designed for a
recessed installation.
•
Leveling
Level the refrigerator so that it rests solidly on the floor
without rocking.
2.
•
Leveling legs located near each front corner of the
refrigerator are adjustable. Turn to raise or lower them.
If necessary, shim under the rear corner.
•
Attach the ground wire
3.
Keep away from heat or direct sunlight
Place your refrigerator away from any heat source and
out of the direct sunlight.
4.
•
High surrounding temperature will lower cooling efficiency
and increase your electricity bill.
•
Keep away from water and moisture
Place the refrigerator in an area with low moisture.
Splashing water or a high moisture area may cause
a short circuit or rusting.
5.
•
10 cm.
15 cm.
30 cm.
Installation/Features Diagram
Refrigerator
Unit
Ground Wire
2.4 meters
To Next Page
Loading...
Need help?
General
