7
How to Operate
1. Your refrigerator is cleaned at the factory but may want to clean it before use.
2. After cleaning put the parts back in their original position.
3. Plug the power cord into an outlet.
4. Before storing food in your refrigerator. run for 2 to 3 hours to allow the
refrigerator to get cold. Allow 24 hours for the temperature to stabilize.
HOW TO DEFROST
HOW TO OPERATE
BEFORE USE
How to Operate
FREEZER COMPARTMENT
The freezer compartment should be
and economical operation at low power consumption. Frost should not be allowed
to grow thicker than 5 mm. (0.2 inches).
kept free of the frost for good freezing effects
Scrape frost off the freezer compartment walls with the scraper supplied
your refrigerator. This can be done without stopping operation.
with
REFRIGERATOR COMPARTMENT
The cooling (evaporator) unit in the refrigerator compartment is automatically
defrosted whenever the compressor motor stops running. No manual control is
required. Frost may grow thick temporarily if the room temperature is high or
the door is opened frequently. Under normal condition, however, it will disappear
disappear after a period of operation.
After a long period operation, frost in the freezer compartment may become
too hard to be removed with a scraper. If it does, set the temperature control
dial to “0” or “OFF” leave the freezer compartment door open for several
minutes, and wipe the freezer compartment wall clean of frost with a hot towel.
After that, wipe the walls dry and reset the control dial.
While defrosting
DRAIN CAP
DRAIN BULB
2.
1.
While defrosting, pull the DRAIN CAP out from the
DRAIN BULB as illustrated. The DRAIN CAP is inside the
freezer compartment.
When defrosting is completed, fit the DRAIN CAP back
to the place.
DEFROSTING
To Next Page
Loading...
Need help?
General
