HOW TO OPERATE YOUR DISHWASHER
Your dishwasher is designed to give maximum
performance on
loads
with normal
and
heavy soils.
You may find that many
of your dishes have lighter
soils than normal;
if
this is the case you can save
water and energy by selecting a
cycle
other than
NORMAL WASH.
NOTE: The lights over the Cycle and Energy Option
pads come ON to indicate the cycle/option that has
been selected. Press pad firmly
until
the light comes
on. These Cycle and Energy Option Indicator lights
remain on while the door is latched.
The CYCLE ON light will come on when the
dishwasher is in a Start Delay, Wash or Dry
cycle.
The light will go out when all cycles are complete.
If dishwasher drains into a food waste disposal,
operate the disposal until it is empty before starting
dishwasher.
step
1.
Load your dishwasher. (See
Loading section.)
step
2.
Make sure the Cycle Indicator Dial is at
the OFF position and the CYCLE ON light is off,
indicating all cycles are complete.
step
3.
Latch the door.
step
4.
Select desired wash cycle.
● POTSCRUBBF.R—For items such as pots, pans
and casseroles with dried-on or baked-on soils.
Everyday dishes may be included. This cycle will
get heavily soiled dishes cleaner than the normal
cycle. It
will
not remove burned-on foods.
● NORMAL WASH—For most loads of everyday
dishes, glasses and cookware with medium soils.
Designed to yield high performance on normal soils.
● LIGHT WASH—For
loads
that have dishes with
light soils.
● WATER SAVER—For dishes with
1
ight
soi
Is. This
cycle
saves water by using 3070 less water than the
NORMAL WASH cycle.
step
s.
Select the desired Energy Options.
● WASH HEAT BOOST—Use this option for
best performance with heavily-soiled dishes.
When selected, the wash
cycle
is extended while
the dishwasher heats the water for the best washing
and drying. (See Cycle Selection Chart. )
● HEATED DRY—Turns the drying heater on for
fast drying. When selected, the cycle time will be
extended for
32
minutes.
POT- NORMAL
#::j
WATER WASH HEAT
H:;]EO
O[:~O&S
SCRUBBER WASH
6666660
Cycles
L
Energy Options
A
● HEATED DRY off—Shuts off the heating unit,
thus saving energy. Dishes air-dry
naturall]. It takes
longer
but saves energy. You can open the door after
the motor stops to speed drying. Excellent for
overnight drying.
●
OPTIONS RESET—Turns
all
Energy
Options off.
Step
6. Turn the Cycle Indicator Dial to START
or to the desired START DELAY time.
● Turning the dial to START will begin the cycle
immediately. To obtain the benefits of a complete
cycle, be careful that you do not turn the dial any
farther than is necessary to start the dishwasher.
There is a time delay between start-up and water
fill so you will not hear any wash action right away.
● The START DELAY will allow you to delay the
start time of your dishwasher automatically for up
to 6 hours. Turn the Cycle Indicator Dial to the
desired time. The CYCLE ON light will come on.
Dial Cycles
The SHORT WASH cycle allows you to quickly
wash loads of everyday dishes with medium soils
that have not dried on, such as loads consisting mostly
of glasses. Start Delay
cannt)t
be
u.~ed
with
thi.v
cycle.
a. Select the NORMAL WASH cycle and any
Energy Option of desired.
b. Be sure the door is unlatched.
c.
Slowly
turn the Cycle Indicator
Dial
to
SHORT WASH.
d. Latch the door to start the
cycle.
To Next Page
Loading...
Need help?
General
