When reversing the door swing:
Read the instructions all the way through before
starting.
Handle parts carefully to avoid scratching paint.
Set screws down by their related parts to avoid using
them in the wrong places.
Provide a non-scratching work surface for
the doors.
IMPORTANT: Once you begin, do not move the cabinet
until door-swing reversal is completed.
These instructions are for changing the hinges from
WKHULJKWVLGHWRWKHOHIWVLGH³LI\RXHYHUZDQWWRFKDQJH
the hinges back to the right side, follow these same
instructions and reverse all references to left and right.
Unplug the refrigerator from its electrical outlet.
(PSW\DOOGRRUVKHOYHVLQFOXGLQJWKHGDLU\
compartment.
IMPORTANT NOTES
5/16s socket and ratchet
TOOLS YOU WILL NEED
Phillips screwdriver
Putty knife or
thin-blade screwdriver
Masking tape
21
Installation Instructions
REVERSING THE DOOR SWING
REMOVE FREEZER DOOR
1
Tape the door shut with masking tape.
Remove the tape and tilt the door away from the
cabinet. Lift it off the center hinge pin.
NOTE: Do not misplace the washer located on the top
side of the center hinge pin.
Set the door on a non-scratching surface with
the inside up.
Remove the hinge cover on top of the freezer door.
Remove the four screws with a 5/16ssocket and
ratchet, then lift the hinge straight up to free the hinge
pin from the socket in the top of the door.
Top Hinge
To Next Page
Loading...
Need help?
General
