EasyManuals Logo
Home>GE>Ranges>JCS968

GE JCS968 User Manual

GE JCS968
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
34
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
Cleaning the glass cooktop.
Allow the cooktop to cool.
Use a single-edge razor blade
scraper at approximately a 45°
angle against the glass surface
and scrape the soil. It will be
necessary to apply pressure to
the razor scraper in order to
remove the residue.
After scraping with the razor
scraper, spread a few drops of
Ceramic Cooktop Cleaner on the
entire burned residue area. Use
the Cleaning Pad to remove any
remaining residue.
For additional protection,
after all residue has been
removed, polish the entire
surface with Ceramic Cooktop
Cleaner and a paper towel.
The Ceramic Cooktop Scraper and
all recommended supplies are
available through our dealers or
through a Mabe Parts Store.
NOTE: Do not use a dull or
nicked blade.
Heavy, Burned-On Residue
Normal Daily Use Cleaning
ONLY use Ceramic Cooktop Cleaner on
the glass cooktop. Other creams may not
be as effective.
To maintain and protect the surface of
your glass cooktop, follow these steps:
Before using the cooktop for the
first time, clean it with Ceramic
Cooktop Cleaner. This helps
protect the top and makes
cleanup easier.
Daily use of Ceramic Cooktop
Cleaner will help keep the cooktop
looking new.
Shake the cleaning cream well.
Apply a few drops of Ceramic
Cooktop Cleaner directly to the
cooktop.
Use a paper towel or Cleaning Pad
for Ceramic Cooktops to clean the
entire cooktop surface.
Use a dry cloth or paper towel
to remove all cleaning residue.
No need to rinse.
NOTE: It is very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughly.
Clean your cooktop after
each spill. Use Ceramic
Cooktop Cleaner.
Begin by locking the cooktop; see the
Control Lockout section.
Control Lockout
09
VERROUILLAGE CONTROLES
CONTROL LOCKOUT
Burned-On Residue
WARNING: DAMAGE to your glass surface
may occur if you use scrub pads other than the
pad included with your cooktop.
Allow the cooktop to cool.
Spread a few drops of Ceramic
Cooktop Cleaner on the entire
burned residue area.
Using a Cleaning Pad for Ceramic
Cooktops, rub the residue area,
applying pressure as needed.
If any residue remains, repeat the
steps listed above as needed.
For additional protection, after all
residue has been removed, polish
the entire surface with Ceramic
Cooktop Cleaner and a paper
towel.
Use a Cleaning Pad for Ceramic
Cooktops.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE JCS968 and is the answer not in the manual?

GE JCS968 Specifications

General IconGeneral
BrandGE
ModelJCS968
CategoryRanges
LanguageEnglish

Related product manuals