GE JGBS10 User Manual

MATERIALS YOU MAY NEED
• Gas line shut-off valve
• Pipe joint sealant or UL-approved pipe thread
tape with Teflon* that resists action of natural
and LP gases
• Flexible metal appliance connector (1/2 ″ I.D.)
A 5-foot length is recommended for ease of
installation but other lengths are acceptable.
Never use an old connector when installing a
new range.
• Flare union adapter for connection to gas
supply line (3/4 ″ or 1/2 ″ NPT x 1/2 ″ I.D.)
• Flare union adapter for connection to
pressure regulator on range (1/2 ″ NPT x 1/2 ″
I.D.)
• Liquid leak detector or soapy water.
• Lag bolt or 1/2″ O.D. sleeve anchor (for
concrete floors only).
*Teflon: Registered trademark of DuPont
FOR YOUR SAFETY
Do not store or use combustible materials,
gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.
If you smell gas:
Open windows.
Don’t touch electrical switches.
Extinguish any open flame.
Immediately call your gas supplier.
TOOLS YOU WILL NEED
Flat-blade screwdriver
Pipe wrenches (2)
(one for backup)
Phillips screwdriver
Open-end or
adjustable wrench
Pencil and ruler
Level
PART INCLUDED
Anti-tip bracket kit
27
Installation Instructions
Drill, awl or nail

GE JGBS10 Specifications

General

Brand	GE
Model	JGBS10
Category	Ranges
Language	English