GE JSP38 Installation Instructions

10
Installation Instructions
INSTALL THE RANGE
REMOVE OVEN DOOR
Before installing the range, you may remove
the oven door to lessen the weight of the
unit. DO NOT lift unit by door handle.
To remove oven door:
Open the door to the stop position.
See Fig. 19A.
Grasp the door at each side and lift up
and off the hinges. See Fig. 19B.
CAUTION:
When the door
is removed and hinge arms are
at stop position, do not bump or
try to move the hinge arms. The
hinges could snap back causing an injury to
the hands or damage to the porcelain on the
front of the oven. Cover the hinges with
toweling or insert empty towel rolls behind
the hinges while working in the oven area.
B
A
1
LEVEL THE RANGE
For proper cooking and baking the range
must be leveled. Do not place range in cutout
until you are sure that the flanges below the
sides of the cooktop are above the top of the
counter. Lift cooktop to see flanges. Damage
to the cooktop could result if adjusted
improperly.
Install the oven racks (see use and care
section for instructions).
Use a 1-3/8″ open end wrench or an
adjustable wrench to equally back out
the four leg levelers until the flanges
(rims) below the sides of the maintop are
above the top of the counter. Check by
measuring the height of the counter and
comparing it with the measurement from
the floor to the flanges below the sides of
the cooktop. Place range in cutout when
adjustments are complete.
Put a spirit level or a glass measuring cup
partially filled with water on one of the
oven racks. See Fig. 21.
Use the wrench to adjust the leg levelers.
Level range front to back and side to side.
See Fig. 20.
D
C
B
A
2
Fig. 19B
Fig. 20
Fig. 21
Fig. 19A
Stop Position
Hinge
Lower Range
Raise
Range
Spirit Level
Leg Leveler

GE JSP38 Specifications

General

Brand	GE
Model	JSP38
Category	Ranges
Language	English