Position the range in front of the
cabinet opening.
SLIDE RANGE INTO OPENING
9
Installation Instructions
Installing the Range
E
E1
E8
Make sure that the glass which
overhangs the countertop clears the
countertop. Raise the unit by lowering
the leveling legs if necessary.
E2
Push while lifting the range into the
opening until the range is within 2” of
engaging the anti-tip bracket
E3
E4
Remove the protective trim from the
side of glass. (If provided)
E5
Using the adjustable pliers or wrench
carefully screw in the back leveling leg
until the glass overhang comes to rest
on the counter top.
E6
Then carefully screw in the front two
leveling legs (similar to E5) until the
glass overhang touches the
countertop.
Plug range cord into receptacle. Locate
the cord in the back of the range in a
manner that will not touch or be moved
by the drawer.
Continued on following page
Countertop
Make sure the edge
of the countertop fits flush
against the end of the
Front Control Panel
E7
Carefully push the range into the
opening until the counter top fully
engages the control panel. The back
glass overhang should cover the cutout
opening.
STORAGE DRAWER
POSITION RANGE CORD
SO THAT THERE IS NO
INTERFERENCE WITH
STORAGE DRAWER
Adjustable Wrench
or Pliers
To Next Page
Loading...
Need help?
General
