To Next Page

To Previous Page

Installation Instructions

INSTALLING THE DOWNDRAFT VENT SYSTEM

30" COOKTOP/DOWNDRAFT

UNIT JVB37

NOTE: Before you begin, measure and mark

Dimension 3 to ensure that adequate flat

countertop surface is available.

Identify the cutout illustration for the cooktop

model you are installing with this downdraft

vent system.

• Draw lines on the countertop to follow

as a cutting guide.

• Make sure sides of the opening are

parallel and rear and front cuts are exactly

perpendicular (right angle) to sides.

|l_J]ll_l_m .I|_H i |l_l_.l Llo iw* r. 1.1_ 011J _,lJ] 0 }.ITJ f E_,r.ll_| LJl_|l,ll

[] [] [] [] [] []

Overall Cooktop Surface Surface Depth Minimum Setback Combined Combined

Model No. Width Overall Depth with Downdraft* Cutout to Front Edge** Cutout Width Cutout Depth

JP326 30-1/4" 21-1/4" 23-3/8" 2-1/2" 28-1/2" 22-3/8"

JP340

JP350

JP930 29-3/4" 20-7/8" 23" 2-1/2" 28-1/2" 22-1/4"

JP931

JP938

JP939

JP350SC

JP930SC 29-7/8" 21-1/2" 23-5/8" 2-1/2" 28-1/2" 22-3/8"

JP938SC

JGP328

JGP933 30" 21" 23-1/8" 2-1/2" 28-1/2" 22-3/8"

JGP933S

JGP336 30" 21" 23-1/8" 2-1/2" 28-1/2" 22-1/4"

JGP932 29-3/4" 21" 23-1/8" 2-1/2" 28-1/2" 22-1/4"

JGP930S 30" 21-1/4" 23-3/8" 2-1/2" 28-1/2" 22-1/4"

JGP932S 29-7/8" 21-5/8" 23-3/4" 2-1/2" 28-1/2" 22-5/8"

*includes 1/8" gap between cooktop and vent trim

**Required to maintain UL or AGA approvals

GE JVB37 Owner's Manual And Installation Instructions

Other manuals for GE JVB37