Operating Instructions
Safety Instructions
Installation Instructions
Troubleshooting TipsCustomer Service
Installation of the downdraft system.
Read these instructions completely and carefully.
30″ Cooktops/Downdraft Unit JVB37
NOTE: Before you begin: Measure and mark Dimension 3 to ensure that adequate flat countertop
surface is available.
■ Identify the cutout illustration for the cooktop
model you are installing with this downdraft vent.
■–Draw lines on the countertop to follow as a cutting
guide.
■–Make sure sides of the opening are parallel and
rear and front cuts are exactly perpendicular to sides.
Planning Installation 30” Electric & Gas Cooktops with Downdraft Vents Preparing Cutout
Cooktop Surface Surface Depth Minimum Setback Combined Cutout Combined Cutout
Model No.
Overall Width Overall Depth with Downdraft Cutout to Front Edge Width Depth
JP326 30-1/4″ 21-1/4″ 23-3/8″ 2-1/2″ 28-1/2″ 22-3/8″
JP340 29-3/8″ 20-1/2″ 22-5/8″ 2-1/2″ 28-1/2″ 21-15/16″
JP350
JP360
JP930
JP930S 29-3/8″ 21-7/16″ 23-9/16″ 2-1/2″ 28-1/2″ 22″
JGP326 30-1/4″ 21-1/4″ 23-3/8″ 3-1/4″ 28-1/2″ 22-1/4″
JGP336 30″ 21″ 23-1/8″ 3-1/4″ 22-1/2″ 22-1/8″
JGP930
JGP930S 30″ 21-1/4″ 23-3/8″ 3-1/4″ 28-1/2″ 22-1/4″
10
2
1
⁄
8
″
8
1
⁄
2
″
To Next Page
Loading...
Need help?
General
