GE JVM1620 User Manual

If the model is not vented
to the outside, the air will
be recirculated through a
disposable charcoal filter
that helps remove smoke
and odors.
The charcoal filter should
be replaced when it is
noticeably dirty or
discolored (usually after
6 to 12 months, depending
on hood usage).
The charcoal filter
cannot be cleaned. It
must be replaced.
Charcoal Filter
(on some models)
When removing the
charcoal filter, disconnect
power at the main fuse or
circuit breaker panel or
pull the plug.
1 Remove the 2 retaining
screws from top air grille
and detach it from
microwave.
2 Gently pull back on the
lower bracket tabs and
lift the bottom portion
of filter upward to
release it from the filter
bracket and remove.
3 Follow steps listed in “To
Install Charcoal Filter” to
replace the charcoal
filter.
To Remove
Charcoal Filter
When installing the
charcoal filter, disconnect
power at the main fuse or
circuit breaker panel or
pull the plug.
1 Remove the 2 retaining
screws from top air grille
and detach it from
microwave.
2 Discard plastic wrapping
from new charcoal filter
and install upwards at a
45° angle.
3 Push filter inward until
secured beneath the top
center tabs of the filter
mounting bracket.
4 Lower the filter until the
bottom section is
secured in place with the
lower bracket tabs.
5 Replace the grille and
retaining screws.
To Install
Charcoal Filter
Helpful Information
45
Charcoal Filter
Front Grill
Retaining Screws
Charcoal Filter
32

GE JVM1620 Specifications

General

Brand	GE
Model	JVM1620
Category	Microwave Oven
Language	English