To Next Page

To Previous Page

DETERMINING MOUNTING PLATE LOCATION UNDER YOUR CABINET

Your cabinets may have decorative trim that interferes

with the microwave oven installation. You may need to

remove the decorative trim to install the microwave oven

properly and to make it level.

THE MICROWAVE OVEN MUST BE LEVEL.

Use a level to make sure the cabinet bottom is level.

If the cabinets have a front overhang, install the

mounting plate down the same distance as the front

overhang depth. This will keep the microwave oven level.

Measure the inside depth of the front overhang.

Draw a horizontal line on the back wall an equal

distance below the cabinet bottom as the inside depth

of the front overhang.

For this type of installation with front overhang,

align the mounting tabs with this horizontal line, not

touching the cabinet bottom as described in Step D.

Plate Position – flat bottom cabinet

PlatePosition–cabinetwithfrontoverhang

Mounting Plate Tabs

Touching the Cabinet

Bottom

Mounting Plate

with Tabs Below

Cabinet Bottom

the Same Distance

as the Front

Overhang Depth

At least 30″, up to 36″

Plate Position – recessed cabinet bottom

Mounting Plate

Tabs Touching the

Back Frame of the

Cabinet

30″ to Cooktop

Installation Instructions

1” = 2.5 cm; 1’ = 0.3 m

GE JVM1635 Installation Instructions

Other manuals for GE JVM1635