GE JVM1635 Installation Instructions

OUTSIDE TOP EXHAUST (Vertical Duct)
Insert the toggle wings into the holes in the wall and
place the mounting plate against the wall.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed flush against the
wall and that the plate is properly centered under the
cabinet.
CAUTION: Becarefultoavoidpinching
fingersbetweenthebackofthemountingplateand
the wall.
Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
3
B
4
ATTACH THE MOUNTING PLATE
TO THE WALL
B1
16
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud. Recommended locations on the mounting
plate are indicated by A, B, C and D.
Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate through
the holes designated to go into drywall and reattach
the toggle wings to
3
⁄4″ onto each bolt.
1
Popc
orn
Convenience Cooking
Expr
ess Cook
Pota
to
Start
P
a
use
Cancel
O
ff
Beverage
Reh
eat
Set
Cl
ock
Turntable
Surface
Light
V
ent
Add
30
Sec.
Power
Level
0
8
5
2
7
4
1
9
6
3
Cook
T
ime
Defro
st
W
e
igh
t
/T
im
e
T
imer
O
n
/
O
ff
INSTALLATION OVERVIEW
B1. Attach Mounting Plate to Wall
B2. Prepare Top Cabinet
B3. Adjust Blower Motor
B4. Install Exhaust Adaptor
B5. Mount Microwave Oven
B6. Adjust Exhaust Adaptor
B7. Connect Ductwork
Wall
Mounting
Plate
Mounting Plate
Spacing for Toggles More
Than Wall Thickness
Bolt End
Toggle
Bolt
Toggle Wings
To use toggle bolts:
Installation Instructions
2
A
B
C
D
1” = 2.5 cm; 1’ = 0.3 m

GE JVM1635 Specifications

General

Brand	GE
Model	JVM1635
Category	Microwave Oven
Language	English