5–28 MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL
IP ADDRESSING CHAPTER 5: IP ADDRESSING
In the example below “system” module box has been checked. In this case after kill Config
command is issued by pressing the OK button, the Switch will perform a factory dump
restoring all the Switch settings back to factory defaults except for the “System” settings
which will be retained.
When the OK button is pressed the Switch will issue the following warning messages; and
reboot the switch for it to revert back to the factory default settings with the exceptions of
modules opted not to be defaulted.
To Next Page
Loading...
Need help?
General
