49-1000464 Rev. 0 9
Care and Cleaning
UNDERSTANDING THE DISPLAY
Understanding the display
Removal of Mineral Deposits
1.Fillthereservoirwithwhitevinegartothemaxfilllineandrunuptothreecleaningcycles.Or
purchase an Opal Cleaning Kit and follow instructions inside.
2.Ifusingvinegar,leavethevinegarintheunitfor18hoursandsetavinegar-soakedtowelon
theicechuteovernighttofurtherdissolveanymineralbuildup.Seefigure10.
3. Clean the sensors with vinegar and wipe clean with water. After draining the vinegar, run
threerinsecycles,usingfreshwaterforeachrinse.Seefigures11,12,and13toreference
location of the sensors.
Cleaning the Bin and Tray
To clean the ice bin, remove the ice bin from the ice maker and clean with a soft cloth dampened with soapy water.
Rinsethoroughly.Drywithasoftcloth.Do not use solvents or chemicals.
The drip tray should be wiped dry. Water left in this area may leave deposits. To clean the drip tray, remove the tray
fromOpalanduseasoftclothdampenedwithmildsoapywatertogentlycleanthesurface.Drywithasoftcloth.Do
not use solvents or chemicals.
Power
The Power button, when pressed, will begin the ice
making process. When pressed, while ON, will turn the
icemakero.
Light
Thelightfeaturehasthreedierentmodes:ON/DIM/OFF.
Toggle between the three modes by pressing the light
button until you reach your desired lighting mode.
Clean
The cleaning cycle is initiated by pressing and holding
the'Clean'buttonforthreeseconds.
Indicator Lights
Thefourindicatorlightsontheleft-handsideoftheunit
displaythecurrentstatusoftheOpal.If'AddWater'is
highlighted, your unit needs more water before it can
cycle to make ice or clean.
WiFi
UsingthecomplimentaryOpalmobileapp,customers
can connect to their Opal and control it from their Android
oriPhone.Theindicatorlightontheleft-handsidewill
conrmasuccessfulconnection.Seepage14forhowto
connectOpalIceMakertoWiFiApplication.
Making Ice
Defrosting Cleaning
Hold 3 Sec
Add Water
Clean
Light Power
Figure10
Figure11 Figure12
Figure13