EasyManuals Logo
Home>GE>Ranges>P2S920SEFSS

GE P2S920SEFSS User Manual

GE P2S920SEFSS
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
49-85211-1
25
Cleaning The Cooktop (Cont.)
CARE AND CLEANING: Cleaning The Cooktop
Replacing Burner Heads
Replace burner heads in the correct locations according
to size.
Burner Caps
Replace burner caps on burner heads. Make sure each
cap fits securely and sits flat on its corresponding burner
head.
Burner cap is
properly seated.
Burner cap is
NOT properly seated.
Burner cap is
NOT properly seated.
Cleaning The Burners
Burner Caps
Wash burner caps in hot, soapy water and rinse with
clean water. You may scour with a plastic scouring pad
to remove burned-on food particles. The round caps may
also be cleaned in your dishwasher.
Burner Heads
Wash the burner heads routinely, especially after bad
spillovers, which could clog the openings. Lift burners off
when cool. Use hot, soapy water. Rinse with clean water.
For more stubborn stains, use a brush with plastic bristles.
NOTE: Do not use steel wool or scouring powders to
clean the burner parts as these may clog the parts.
Never wash burner heads in your dishwasher as
dishwasher detergents will discolor your burners.
The ports in the burner heads must be kept clean at all
times for an even, unhampered flame.
Clogged or dirty burner ports or electrodes will not allow
the burner to operate properly.
For proper ignition, make sure the small hole in the notch
that fits over the electrode is kept open. A sewing needle
or wire twist-tie works well to unclog it
After cleaning
Before putting the burner caps, heads (on some models)
and oval head/cap assembly back, shake out excess
water and allow them to dry thoroughly.
CAUTION Do not operate the cooktop
without all burner parts and grates in place.
Any spill on or around an electrode must be carefully
cleaned. Take care to not hit an electrode with anything
hard or it could be damaged.
Electrode
Tri-ring base
(on some models)
The electrode of the spark igniter is exposed
when the burner head is removed. When one
burner is turned to LITE, all the burners spark.
Do not attempt to disassemble or clean around
any burner while another burner is on. An electric
shock may result, which could cause you to
knock over hot cookware.
or
Round hole in
burner head must
be kept clear

Other manuals for GE P2S920SEFSS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE P2S920SEFSS and is the answer not in the manual?

GE P2S920SEFSS Specifications

General IconGeneral
Stylesingle oven, slide-in
Colorstainless steel
Total Capacity5.9 cubic feet
Optionsconvection bake, convection roast, dual broil
Cooking Programsconvection
Inductionno
Number of Burners / Elements5
Control Typetouchscreen
Interior Lightyes
Child Lockno
Smart Homeno
Fueldual fuel
Weight and Dimensions IconWeight and Dimensions
Depth29.38 inches
Height39 inches
Width30 inches
Net Weight225 pounds

Related product manuals