8
Programming For DBS Satellite System
Most GE, RCA and ProScan Satellite sys-
tems will not require programming. Check
to see if your DBS Satellite system responds
to the remote before you begin program-
ming.
1. Manually turn on the DBS system. Find
the three digit code for your DBS
system in the code list below.
2. Press and hold the
CODE SEARCH button
until the INDICATOR
LIGHT lights, then
release the CODE
SEARCH button.
3. Press and release the
DBS button (The INDI-
CATOR LIGHT will
blink then
remain lit.
4. Enter the code using
the Number Buttons.
After your code is
entered, the INDICA-
TOR LIGHT will turn
off. If the code is not
valid, the INDICATOR
LIGHT will blink.
Check the code list and
repeat process.
5. Aim the remote at
your DBS system and
press the
ON•OFF button. Your
DBS system should turn
off.
6. With your DBS System on, press
CHAN+ (CHANNEL UP). If the satellite
system responds, no further programming
is required.
NOTE: If your DBS system does not
respond, try all the codes for your brand. If
the codes do not work, or your brand is not
listed, try the Code Search method.
7. Enter your code here for easy reference.
To Next Page
Loading...
Need help?
General
