To Next Page

To Previous Page

Programming With Code Search

If your TV, VCR, DBS Satellite System, Cable Box or

Audio System does not respond after you have tried

all the codes for your brand, or if your brand is not

listed, try searching your code by following the steps

below:

1. Manually turn on the device

you wish to program.

2. Press and hold the CODE

SEARCH until the INDICATOR

LIGHT lights, then release

CODE SEARCH.

3. Press and release the device

button for the device you

are programming. The INDI-

CATORLIGHT will blink

once, then remain lit.

NOTE: For AUX programming

(when not an audio code)

press AUX followed by the

device button.

4. Press and release ON•OFF

until your device turns off.

5. When your device turns off,

press ENTER, the INDICATOR

LIGHT will turn off.

Identifying Codes From Your Universal Remote

If you need to find the three-digit code for your TV,

VCR, DBS System, Cable Box or Audio System after

your device is set-up, use this

procedure.

1. Press and hold CODE

SEARCH until the INDICA-

TOR LIGHT lights, then

release CODESEARCH.

2. Press and release the

device button for the code

you are retrieving. The INDI-

CATORLIGHT will blink

once.

94927 Revised Size 2/25/02 4:19 PM Page 17

GE RM94927 User Manual

Questions and Answers: