18
SOLUTION
If your original remote
required ENTER
after a channel, press
ENTER after you
select a channel.
A) Make sure you have
new batteries and
you are aiming your
remote at your device.
B) Check that batteries
are properly installed.
Try using the DISPLAY
button to make the
selection while in the
Program Guide.
Invalid Code for the
device. Check the Code
list and reprogram the
Remote Control.
Trouble Shooting (con’t.)
PROBLEM
Problems changing channels
No response after pressing a
key
SELECT button not respond-
ing
Flashing Indicator Light
NOTE: Reprogramming may be required after batter-
ies are removed.
94927 Revised Size 2/25/02 4:19 PM Page 19
To Next Page
Loading...
Need help?
General
