Beforeyoucall forservice...
Troubleshooting -tips
Save time and money! Review the charts on the following pages, or
visit www.6EAppliances.com. Youmay not need to call for service.
AUTOTEMP PossibleCauses What ToDo
AutoTemp cold wash The washer is in a cold rinse cycle • This is nomml. Tile AutoTemp teature is designed not
temperature is incorrect to activate during a cold rinse cycle so that the coldest
water available is used,
(ReviewAutoTemp All the water in the water heater • _&.fit tmtil the water in the water heater is heated to the
in the About washer has been used correct teml)erattu'e.
features section)
WATER Possible Causes What To Do
Toomanysuds Type of detergent • Switch to a lower sudsing detergent brand and t011ow
instructions on package.
Very soft water • T_'v less deteroent
Too much detergent • Measure your detergent carefifllv. Use less soap if you
have sott water; a smaller load, or a lightly soiled load,
Water leaks Fill hoses or drain hose is • Make sure hose connections are fight at taucets and
hnproperly comlected rtfl)ber washe_ are installed. Make sure end of chain hose
is correctly inserted in and secured to (lmin ti_cilitv.
Household dxaJn may " Check household pluml)ing. You may need to call a
be dogged pluml)e_:
Construct water pressure • Tighten hoses at the timcets and turn the water off after
to the Fdl hoses at the each use.
water source • Check condition of tile fill hoses; the_ should be
replaced eve_ T 5 vem_.
Using too much detergent • Use less detergent. Use less soap if you have soii water; a
in washer smaller load, or a lightly soiled load.
Water temperature Control is not set properly • Check water temperature control and a(!iust.
isincorrect
Water supply is turned off • Turn both hot and cold taucet,s hilly on and make sure
or improperly cmmected hoses are connected to correct timcets.
Water valve screens are • Turn off tile x_tteI" SOtlrce alld relllove file x_ttei"
stopped up connection hoses fi'om tile upper back of the washei:
Use a brush or tooflq)ick to clean tile screens in file
machine, Reconnect file hoses and turn file water back on,
House water heater is • Make stu'e house water heater is delivering water
not set properly at 120°-140°F (48°-60°C),
Water pumped out Lid rifted or cycle was put in • Reset cycle.
before cycle is pause for over 24 hours
complete
Water won't drain Drain hose is kinked or • Straighten drain hose and make sure washer is not sitting
huproperly comaected on it.
• Top of drain outlet should be less than 8 ft. (2.5 m)
above flooi:
/2
To Next Page
Loading...
Need help?
General
