GE SIMON XT User Guide

System Programming
To enter system programming mode, do the following:
1. Enter the system menu by pressing the scroll up/down buttons or the Enter button in
the upper right of the panel.
2. Scroll up/down to System programming, and then press Enter.
3. The panel displays Enter code.
4. Enter your master code, and then press Enter.
Access codes
There are three types of access codes: master, user, and duress.
Master code. The master code is your most powerful code and can be used for all user
operations including programming. To change the master code, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Access codes, and then press Enter.
3. Scroll up/down to Master code, and then press Enter.
4. The current value of the code now flashes.
5. Enter a new code (use correct length), then press Enter.
6. Press Status repeatedly to exit.
The initial value of the master code is 123, 1234,12345, or 123456, depending on the
installer- programmed access code length.
User codes 1 to 8. There are eight user codes, which can be used for many user
operations, but not sub disarming, programming, or bypassing sensors.
To change a user code, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Access codes, and then press Enter.
3. Scroll up/down to the user code you want to change, and then press Enter.

GE SIMON XT Specifications

General

Brand	GE
Model	SIMON XT
Category	Security System
Language	English