GE Spacemaker JVM1540 User Manual

Before You Call Service
Problem
Possible Cause Whatto Do
Ovenwill not
start
Floorof the ovenis
warm,even when
the oven hasnot
been used
"LOC" appears
on display
Vent fan will not
turn off
"BAD PROBE"
appearson display
"PLEASE INSERT
PROBE" appears
on display
"SENSOR ERROR"
appears on display
A fuse in your home
may be blown or the
circuit breaker tripped.
Power surge.
Plug not fully inserted
into wall outlet.
Door not securely dosed.
The cooktop light is
located below the oven
floor. When the light
is on. the heat it
produces may make the
oven floor get warm.
o Replace fl_se or reset circuit breaker.
o Unplug the microwave oven, then plug
it back in.
o Make sure tile 3-prong plug on tile
oven is flflly inserted into wall outlet.
* Open the door and close securel>
o This is normal.
The control has been o Press and hold CLEAR/OFF tot
locked, about 3 seconds to unlock the control.
o
The vent fan
automatically turns on
to cool internal parts
while the microwave
is on.
The probe has not been
completely inserted into
the oven wall outlet.
The probe is defective.
Probe has been
forgotten or not
inserted properly.
When using a Sensor
feature, the door was
opened before steam
could be detected.
Steam was not detected
in maximum amount
of time.
The vent tim cannot be turned off
while the microwave is operating.
This is normal. Wait for the microwave
to turn off and the tan will either go
off automatically or you will need to
turn it off by pressing the Vent Fan
pad after the microwave is off.
Insert the probe properly into the
oven wall outlet.
o Replace the probe.
o Insert the probe properly into the
oven wall outlet.
Do not open door until steam is
sensed and time is shown counting
down on displa>
o Use Time Cook to heat tot more time.
36

GE Spacemaker JVM1540 Specifications

General

Brand	GE
Model	Spacemaker JVM1540
Category	Microwave Oven
Language	English