EasyManuals Logo
Home>GE>Washer>WDSS4120

GE WDSS4120 User Manual

GE WDSS4120
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
Install or store where it will not be exposed to
temperatures below freezing or exposed to
the weather.
Properly ground washer to conform with all
governing codes and ordinances. Follow details
in Installation Instructions.
2
WATER HEATER SAFETY
Under certain conditions hydrogen gas may be produced in a water heater that has not been used for two
weeks or more. Hydrogen gas can be explosive under these circumstances.
If the hot water has not been used for two weeks or more, prevent the possibility of damage or injury
by turning on
all hot water faucets and allowing them to run for several minutes. Do this before using
any electrical appliance
which is connected to the hot water system. This simple procedure will allow
any built-up hydrogen gas to escape. Since the gas is flammable, do not smoke or use an open flame
or appliance during this process.
PROPER INSTALLATION
This washer must be properly installed and located in accordance with the Installation Instructions
before it is used. If you did not receive an Installation Instructions sheet, you can receive one by visiting
www.GEAppliances.com, or by calling
800.GE.CARES (800.432.2737).
Keep the area underneath and around your
appliances free of combustible materials such
as lint, paper, rags, chemicals, etc.
Close supervision is necessary if this appliance
is used by or near children. Do not allow
children to play on, with, or inside this or
any other appliance.
YOUR LAUNDRY AREA
IMPORTANT SAFETY INSTRUCTIONS.
READ ALL INSTRUCTIONS BEFORE USING.
For your safety, the information in this manual must be followed to minimize the risk of fire,
explosion, electric shock, or to prevent property damage, personal injury, or loss of life.
WARNING!
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips
Do not pause an active cycle for longer than
thirty minutes. Pressure switch may reset and
cause the tub to overfill.
Always turn the Load Size knob to
RESET
before changing a water level.
DO NOT
hold Load Size knob at
RESET
.
Water will continue to fill as long as knob
is held at
RESET
.
OVERFILLING
To reduce the risk of property damage due to flooding of washer unit, follow basic precautions,
including the following:

Other manuals for GE WDSS4120

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE WDSS4120 and is the answer not in the manual?

GE WDSS4120 Specifications

General IconGeneral
BrandGE
ModelWDSS4120
CategoryWasher
LanguageEnglish

Related product manuals