GEIGER GJ5606k Original Installation And Operating Instructions

3
www.geiger-antriebstechnik.de
EN
EN
3. Safety information
I
ATTENTION: Important safety information. For personal safety, it is
important to follow these instructions. The instructions should be
kept.
f This appliance is not to be used by persons (including children) whose
physical, sensorial or mental capacities are impaired, or who have no
expe rience or know-how, unless they have been supervised or been given
instructions on the use of the appliance by someone who is responsible for
their safety.
f Children must be supervised to make sure they do not play with the
appliance.
f The installation is to be checked regularly for defective balance, wear and
damage.
f Damaged connecting leads must be replaced by the GEIGER connecting
lead of the same wire type.
f During operation observe the danger zone.
f If people or objects are in the danger zone, do not use the installation.
f Urgently shut down damaged installations until repair.
f Unconditionally shut down the unit during maintenance and cleaning
operations.
f Pinching and shearing sites are to be avoided and to be safeguarded
against.
f When operating the manual actuator with the open sun protection system,
exercise caution as it can fall down quickly if springs expand or are broken.
f Do not operate the device if operations such as, for example, window
cleaning are to be carried out in the vicinity.
f Disconnect the device from the mains power supply if operations such as,
for example, window cleaning are being carried out in the vicinity.
I
ATTENTION: Important safety information. Follow all installation
instructions, as incorrect installation can lead to serious injuries.
f The motor surface can become very hot during prolonged operation.
Please do not touch the motor during the cool down phase.
f Connection must be carried out by a skilled electrician according to the
regulations in force locally.
f The mains plug of the motor must be accessible after installation.
f On the installation of the motor without mechanical protection of the driven
parts, the motor must be installed at a height of at least 2.5 m above the
ground or of another level which provides access to the drive.
f Before the motor is installed, all leads which are not needed are to be
removed and all equipment which is not needed for actuation is to be put
out of operation.
f If the motor is controlled by a switch or pushbutton, the switch or
pushbutton must be mounted within eyeshot of the motor. The switch or
pushbutton must not be located in the vicinity of moving parts. The height

GEIGER GJ5606k Specifications

General

Brand	GEIGER
Model	GJ5606k
Category	Engine
Language	English