To Next Page

To Previous Page

PROGRAMMING (OPTIONAL)

Enter the User Program Mode

1 Enter your User Code, then press AA to enter the Function Mode.

2 Answer NO (FF) until “ACTIVATE PROGRAM Y/N” is displayed, then press YES

(EE)

“ENTER USER CODE” will display indicating that the system is ready for User Code

programming.

Programming/Reprogramming a User Code

1 Enter the 2 digits of the user number to be programmed, followed by AA.

( Example: for User 4, enter 04 AA).

2 Enter the new User Code (up to 6 digits)

3 Press J to save the new User Code.

Repeat Steps 1 through 3 for each User Code to be programmed.

User Program Mode

Your Installer has programmed into your system a special User Program Code which can be used to not only Arm and Disarm the

system, but also to enter the User Program Mode, where you can program other User Codes, Zone Descriptions and also set the

system Time and Date. The following explains how you will use this code to program or erase additional User Codes:

ACTIVATE

PROGRAM Y/N

ENTER USER CODE

U01 123 - -

ENTER USER CODE

U04 - -

Erasing a User Code

1 Enter the 2 digits of the user number to be erased followed by AA.

2 Press G0 to erase each digit of the User Code and then press J.

3 Example: Erase User 3’s 4-digit User Code:

4 Press 03 AA G0 G0 G0 G0 J.

ENTER USER CODE

UO4 4567 - -

Gemini GEM-RP1CAe2 User Manual

Questions and Answers: