7
SETTING THE ALARM (ARMING) WHEN LEAVING
System Trouble
If you attempt to arm with a “SYSTEM TROUBLE” display alternating with an indicated trouble code (e.g.
“E02-00” (low battery); see SYSTEM TROUBLE ERROR CODES), a 3-second tone will sound at the
keypad. The window will display “PRESS RESET KEY, CAN'T ARM SYSTEM”. If you cannot correct the
problem immediately, pressing C will enable you to arm in this condition. Be sure to call for service as
soon as possible.
Area Arming (Optional)
Some systems may be divided, or partitioned, into smaller independent subsystems, which are referred to
as Areas. In a system that has been partitioned into multiple areas, one or more area may be armed while
others remain disarmed.
Manager's Mode (Optional)
The Manager's Mode allows the user to arm/disarm other areas in a partitioned system. To arm/disarm a
different area:
1 Press the numerical key representing the other area number.
2 Press G followed byJ. The keypad will now provide status and control of that area.
3 Enter your User Code followed by J to arm or disarm the area.
4 Press G followed byJ to return to the home area.
Global Arming (Optional)
To arm all areas simultaneously, press 9, G and enter your code followed byJ.
To disarm all areas simultaneously, press 0, G and enter your code followed byJ.
• The User Code must be valid in all area(s).
• If any zone is not secured, the keypad will display “CAN’T ARM SYSTEM, AREA X IN TROUBLE”,
where X indicates the number of the Area in trouble. All faulted zones in the respective area(s) must
be secured or bypassed. Note: If a system trouble is indicated, the system cannot be armed using
this method.
SYS/TRBL
LOW BATTERY
E02-00 SERVICE
SYS/TRBL
SYSTEM TROUBLE
SYS/TRBL
PRESS RESET KEY
CAN’T ARM
SYSTEM
EXIT TIME 060
PLEASE LEAVE
NOW
CAN’T ARM SYSTEM
AREA X IN
TROUBLE
To Next Page
Loading...
Need help?
General
