signal so you can use main speakers with
either RCA or XLR input connectors. These
outputs are high pass ltered at 85 Hz (See
chapter Bass Management). Additionally,
the LINK RCA output provides a summed
signal of both channels. Use this connector
as a signal output to the next subwoofer
when you want to connect several sub-
woofers together. See chapter “Using Mul-
tiple Subwoofers” for more information.
System Volume Control Connector
This connector allows connecting the
Genelec 9310A Wired Volume Control
which is available as an accessory. When
connected, the 9310A controls the volume
of the whole system, including the main
speakers.
IR IN Connector
If the F Two is used with an infrared type
remote control (see chapter Use with IR
Remote Controls) and the desired location
of the subwoofer does not allow an unob-
structed line of sight to the receiver located
next to the LED in one of subwoofer’s feet,
the IR extension cable provided with the
subwoofer can be connected here. The
receiver end of the cable is then brought
to a location where the IR remote control
reception works conveniently, for instance
close to the IR receiver of a television set
when using the subwoofer and speakers
with a TV.
Subwoofer
placement
Bass Roll-O
Near a wall -2 dB
In a corner -4 dB
Table 1. Suggested Bass Roll-Off settings in
typical situations
Figure 4. F Two remote control
Main loudspeaker model F Two Level Dip switch setting
-10 dB switch +10 dB switch
G One A OFF OFF
G One B OFF OFF
G One B -10 dB Dip ON ON OFF
G Two A OFF OFF
G Two B OFF OFF
G Two B -10 dB Dip ON ON OFF
G Three A OFF OFF
G Three A +10 Dip ON OFF ON
G Three B OFF OFF
G Three B -10 Dip ON ON OFF
G Four A OFF OFF
G Four A +10 dB Dip ON OFF ON
8010A OFF ON
8010A -10 dB Dip ON OFF OFF
8020A OFF ON
8020B OFF ON
8020C OFF ON
8020D OFF ON
8030A OFF ON
8030B OFF ON
8030C OFF ON
8040A OFF ON
8040B OFF ON
M030 OFF ON
Table 2. Suggested Level switch settings with different main loudspeakers
Functions And Controls
HT Mode
Turn this switch to “ON” when you connect a
sound source with its own volume control to
the analog inputs of the F Two. In this mode
the volume control of the F Two does not
have eect on the analog signals. However,
it works with the digital inputs, so you can
use them to connect other signal sources.
ISS Sensitivity Low
If the Intelligent Signal Sensing (ISS) func-
tion switches the subwoofer on when there
is no audio signal present, turning this
switch to “ON” reduces the triggering sen-
sitivity of the function.
ISS
The Intelligent Signal Sensing (ISS) func-
tion monitors the audio signal fed to the
subwoofer. If there is no signal for approxi-
mately 45 minutes, the function switches
the subwoofer to Standby mode, reduc-
ing the power consumption to less than
0.5 Watts. When the signal resumes, the
subwoofer powers up again. There is a
slight delay in the automatic powering up.
In those environments where the subwoofer
is required to be on all of the time, the ISS
VOLUME
UP
VOLUME
DOWN
SELECT
BUTT
MUTE
POWER
To Next Page
Loading...
Need help?
General
