PERIODICAL MAINTENANCE TABLE
In order to achieve safe riding, good performance and reduce pollution, please execute the recommended
maintenance accordingly.
MONTHS/DISTANCE(IN KM)FOR CHECKING
Item
Model
4T
Checking Content
1 or
190
mile
3 or
1865
mile
6 or
3730
mile
9 or
5595
mile
12 or
7460k
mile
15 or
9320k
mile
18 or
11185
mile
Engine oil* 4T BLUR-150:800cc, total 1000cc
BLUR-220: 1,000CC, total1,200cc
R Replace it initially 300km,
and then replace it per 3000 km
Oil Filter BLUR -150
BLUR -220
Replace R replace it per 6000km
Coarse oil filter*
oil draining bolt)
4T
Clean or replace it if necessary C
clean it initially 300km,
and then replace it per 6000 km if necessary
Air cleaner 4T Crack and blockage check. I I I I I I
Air filter 4T Clean or replace it if required I I I R I I
Gear oil* 4T BLUR -150: 90cc, total 110 cc
BLUR -220: 90cc, total 110 cc
R R R R
Disk & drum brake 4T Leaking and function check I I I I I I
Clutch shoes* 4T Check or replace it if necessary I R I
Tires 4T Worn-out check or replace it if
necessary
I I I I I I
Wheel bearing* 4T Fasten tightly if loosen I I I I I I
Front fork* 4T Leaking and function check I I I I
4T
1 or
190
mile
3 or
1865
mile
6 or
3730
mile
9 or
5595
mile
12 or
7460k
mile
15 or
9320k
mile
18 or
11185
mile
Steering head bearing*
4T Check looseness. Adjust it if
required
A A A
Rear absorber* 4T Leaking and function check I I I
Main/Side Stand 4T Function check or replace it if
required
I L I L I L
Nuts, bolts, fasteners 4T Tighten it if required I I I I I I
Battery 4T Recharge the battery it required.
Clear the poles.
I C I C I C
Valve gap* 4T BLUR -150: 0.08mm/ IN&EX
BLUR 220: 0.08mm/ IN&EX
Adjust it when necessary
Spark plug* 4T Clear or replace if required I R I R I R
V belt* 4T Worn out check or replace if
necessary.
A A A
Fuel feeding system* EXCEPT
EMS
Crack and blockage check.
Replace it if necessary.
I R
I
Fuel feeding system *
EMS ONLY
(Injection)
Inspect hose, clamp, and replace
the filter per 15,000km
I I R
Engine idle speed* 4T 4T engine: 1700±100 rpm A A A A A A A
Carburetor idle A/F
Adjustment*
4T Check and adjust referring to
CO/HC Percentage.
A A A A A A A
EMS function check*
EMS ONLY
(Injection)
Inspect EMS function, and clear
the defect memory if necessary
I I I I I I
REMARKS：
：：
：
1. A: adjust C: clean I: inspect, or replace if necessary L: lubricate R: replace
2. Items with “*” mark indicate our recommendation to have it done by Genuine dealer.
NOTE 1：
：：
：
For 4T engine, the engine oil shall be changed completely after run-in period 300km or one month later.
This can make sure the engine runs smoothly.
NOTE 2：
：：
：
The exchange of brake fluid
1. After disassembling of brake main cylinder or caliper, do change the new fluid.
2. Check the fluid level often, Refill if necessary.
To Next Page
Loading...
Need help?
General
