LCD Monitor User's Manual
-
23
-
USING THE DEVICE
Turning the Power On/O
Make sure the power switch next to the AC power input jack is switched to ON.
Power On
1. Connect one end of the power cable to the AC IN jack at the rear of the monitor.
2. Connect other end of the the power cable to a power outlet.
3. Press the Control button to turn on the monitor. The Power LED will light in
white, indicating the monitor is ready to use.
Note: If the Power LED remains o after you turn on the monitor, please check the LED Indi-
cator setting in the Settings menu. Refer to page 37.
Note: When monitor power on, RGB LED on the rear side of monitor will turn o automatically
after 15 seconds in default setting. Please check the RGB LED setting in the System menu for
select dierent RGB LED patterns.
Power O
Press the Control button for 2 seconds to turn o the monitor.
Note: When the Main menu appears on the screen, you can also turn o the monitor by
moving the Control button down ( ). Refer to page 28.
To Next Page
Loading...
Need help?
General