- 114 -
BIOS Setup
# of Beeps Description
1 Memory not Installed.
1 Memory was installed twice (InstallPeiMemory routine in PEI Core called twice)
2 Recovery started
3 DXEIPL was not found
3 DXE Core Firmware Volume was not found
4
Recovery failed
4 S3 Resume failed
7
Reset PPI is not available
# of Beeps Description
1 Invalid password
4 Some of the Architectural Protocols are not available
5 No Console Output Devices are found
5 No Console Input Devices are found
6 Flash update is failed
7 Reset protocol is not available
8 Platform PCI resource requirements cannot be met
5-8 BIOS POST Beep code (AMI standard)
5-8-1 PEI Beep Codes
5-8-2 DXE Beep Codes
To Previous Page
Loading...
Need help?
General