Program execution mode 18
Cod. 598144
Rev. 11/0717
USA / CANADA programs
EH020 and REM025 models. SP-1, SP-2, SP-3
Other EH, REM and RMG models.SP-1
WARM
Color-fast. Perm press
AREA OF USE JPN in CONFIGURATION menu
Program contents
CP option OFF (CP-0) in the MACHINE CONFIGURATION menu.
The content of the four programs is the same as in the Programs for general application configuration -
HS, RMS and RMG models.
CP option ON (CP-I) in the MACHINE CONFIGURATION menu.
The content of the first three programs is the same as in the Programs for general application
configuration - HS, RMS and RMG models.
Program 4 transforms into a program of very short duration (less than 2 minutes), designed for washing
the machine’s drum before loading the clothes for a wash cycle.
The values of the DRUM CLEANING program cannot be modified, except for the bath level, which will
be the level programmed in Phase 6 of this program.
See Sections 6.1 and 6.2 for further information.
4.6. Unbalance control
Before starting the spin, the washing machine’s electronic control checks the correct distribution of the load.
If it detects that the load is not well distributed and that can cause an excessive unbalance during the spin, a new
positioning of the clothes will be carried out.
If there’s still unbalance during the spin of the last phase, the washer can end the washing cycle reducing the
spin speed. If this is the situation, the report End/bAL will be showed alter the delay of the door opening.
Unbalance control with a micro-switch. Activates only in cases of extreme unbalance.
To improve the efficiency of the washer’s spin, it is advisable to:
Load the washer until its nominal value
Load the washer with homogeneous loads
To Next Page
Loading...
Need help?
General
