8
Care and Cleaning
□ Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the nish and void
your warranty.
Troubleshooting
Replacement Parts
PROBLEM POSSIBLE CAUSE SOLUTION
There is low water pressure or
a missing spray pattern.
The showerhead spray
nozzles are clogged.
Soak the showerhead in a solution of water and vinegar. Use a solution of 50% white vinegar and 50%
water overnight. The vinegar will break down any mineral deposits or sediment from hard water and will
improve the ow through your showerhead.
Debris has clogged the
shower arm or showerhead.
Remove the showerhead and rinse debris from internal parts.
Turn on the hot and cold water and let it run for at least 30 seconds to ush debris from the lines.
Reinstall the showerhead.
The shower bar/showerhead
connection is leaking.
The showerhead connection
is loose.
Gently and rmly tighten the showerhead to the shower bar, but do not overtighten.
The shower bar connection
is loose.
Gently and rmly tighten the shower bar to the shower arm, but do not overtighten.
The thread seal tape is not
creating a good seal.
Remove the shower bar from the shower arm to conrm thread seal tape was applied properly.
Remove and reapply thread seal tape, if needed.
The shower hose/ showerhead
connection is leaking.
The handheld showerhead
connection is loose.
Gently and rmly tighten the handheld showerhead, but do not overtighten.
Part Description Part # 8654252HC-GBBN Part # 8654252HC-GBMB
1 Shower arm connector/Lock nut RP 90132BN RP 90132MB
2 Shower bar/Shower holder RP 90134BN RP 90134MB
3 Adhesive pad, screws and anchors RP 90133 RP 90133
4 Thread seal tape RP 00300 RP 00300
5 Washers RP 00301 RP 00301
6 Shower hose RP 90081 RP 90084
7 Handheld showerhead RP 90130BN RP 90130MB
8 Fixed mount showerhead RP 90131BN RP 90131MB
1
2
3 4 5 6 7 8
To Next Page
Loading...
Need help?
General
