READY-TO-DISPENSE INDICATOR LIGHTS
RED
FLASHING Heater (hot water tank) is operational
STEADY ON The hot water has reached optimum
temperature and is ready for dispensing
OFF Hot water tank heating system is off, however
water within the tank may still be very hot,
always exercise caution when dispensing and/
or draining water from the hot water tank
BLUE
STEADY ON The cold water has reached optimum
temperature and is ready for dispensing
OFF The cooling cycle is in progress. It is possible
to dispense water during the cooling cycle,
however, optimum cooling temperature may
not yet be achieved
YELLOW
FLASHING Low water level inside internal reservoir. The
water bottle is empty
OFF The status of all water levels are normal
Operation
1. DISPENSING ROOM AND COLD WATER
1
2
3
1
2
3
2. ADJUSTING THE TEMPERATURE (COLD WATER ONLY)
NOTICE: This model Water Dispenser left the factory
with the cold water temperature control factory “default
setting” positioned for “Energy Star” compliance
(identied to the side). This setting will deliver cold water
temperatures between 8°C ~ 10°C (46.4°F ~ 50°F) The
cold water temperature can be adjusted, (using a at
screwdriver) by rotating the adjustment screw clockwise
or anti-clockwise between “Min” (cool) and “Max” (colder)
until the desired temperature is reached. NOTE: Any
change/adjustment to the cold water temperature control
may eect Energy Star eciency.
Max
Min.
TEMP
To Next Page
Loading...
Need help?
General
