3. DISPENSING HOT WATER
Important: Your Vitapur® water dispenser is designed with a special safety
feature (low water level sensor) that controls activation/operation of the Kettle
Feature hot water tank heating system. If no water is present and/or low water
levels are detected inside the internal water reservoir, activation/operation of
the Kettle Feature hot water heating system is not possible. Likewise, if the hot
water heating system is operational and water is being drawn simultaneously
causing internal water levels to drop below the established minimal level set
point, hot water tank operation is automatically suspended. To reactivate the
hot water heating system, you must replenish your water supply. Operation of
the cold water system is not affected by this safety feature.
2
3
1
4
Care and Cleaning
CLEANING THE OUTSIDE OF THE WATER DISPENSER
CLEANING THE DRIP TRAY
CLEANING THE CONDENSER
1
2
1
2
1
2
3
WATER
OR
SOAP
WATER
DISPENSER
CLEANER
5
6 7
8
WATER
SOAP
To Next Page
Loading...
Need help?
General
