Go Power GP-DURALITE-100 User Manual

[page 18] | gpelectric.com
®
15. EXPANSION CONNECTION & WIRING DIAGRAM
1. Connect the singular end of the branch connector (Duralite part #10) to the solar controller.
2. Place the solar controller (Duralite part #3) on the leg of the main solar kit using the Velcro fastener provided.
3. Connect the expansion cable (Expansion part #4) to the DC port (Duralite part #10) of the expansion panel.
4. Connect the other end of the expansion cable to the branch connector.
5. Repeat if conecting another expansion panel.
You do not need to utilize all 3 connections on the branch connector for the expansion kit to function.
Connections are to be made red to red, black to black. You will hear a “click” when the connection has been made properly.
15.2 WIRING DIAGRAM
15.1 CONNECTING EXPANSION KIT(S)
(Expansion Part #3)
Extension Cable
3 Way Expansion Harness
(DuraLite Part #10)
Solar Controller
(DuraLite Part #3)
DuraLite 100W Expansion Kit DuraLite 100W Expansion KitDuraLite 100W Base Kit
Connect to DC
port of Base Kit
Connect to
DC port of
Expansion
Kit
Connect to
DC port of
Expansion
Kit
Note
Connect
singular
end to
connector
on solar
controller
(Expansion Part #3)
Extension Cable

Go Power GP-DURALITE-100 Specifications

General

Brand	Go Power
Model	GP-DURALITE-100
Category	Solar panel
Language	English