Go Power GP-RVC-R User Manual

gpelectric.com | [page 7]
3. Setting Screens
The settings screens are used to view and edit settings and also to issue commands to the controller. The following
steps can be used to get to the settings screens shown as [MENU9] to [MENU16] and navigate through them. A
detailed explanation of each setting parameter is included in a table in section 4 below.
Long press [ENTER] button go to system setting interface
Short press [BACK] button quit setting interface and go to main interface
Short Press [DOWN] button to move down by one setting (the curser wraps back to top when you reach the bottom)
Short press [UP] button to move up by one setting (the curser wraps back to bottom when you reach the top)
Press [ENTER] on a setting to edit and use [DOWN] and [UP] to change value. [ENTER] locks setting in and
[BACK] cancels setting.
10A controllers do not have BAT2 parameters
Each time the [DOWN] [UP] buttons are pressed, it will enter next interface
The small black triangle before the parameter item indicates the currently selected item
When the user sets the parameter, the value of the parameter item will ash, and the user can change the
setting.
USER INTERFACES
Note
Note
Note
Note

Go Power GP-RVC-R Specifications

General

Brand	Go Power
Model	GP-RVC-R
Category	Monitor
Language	English