Gorenje GV643D60 User Manual

Clean filter
The filter traps larger food particles, which cannot get past the drainage pump. Empty the filter when
necessary. It should be cleaned at regular intervals depending on how often the dishwasher is used.
1. Turn the locking ring anticlockwise and lift the filter straight up.
2. Empty and clean the filter.
3. Refit the filter and turn the locking ring clockwise to its stop position. Check that the edges seal
properly.
NOTE!
Dishwashing results may be affected if the filter is fitted incorrectly. The dishwasher must not be
used without the filter in place!
Check that the yellow
drainage pump stop on the
right in the bottom drain is in
place.
Cleaning the spray arms
Holes and bearings can sometimes become blocked. Remove any debris using a pin or the like. The
spray arms also have holes underneath.
To facilitate cleaning you can remove the spray arms. Remember to fit them firmly back into place
afterwards.
Top spray arm
• Pull out the top cutlery tray. Push up on the top spray arm while turning it anticlockwise to release
it.
21

Gorenje GV643D60 Specifications

General

Control type	Touch
Product size	Full size (60 cm)
Tub material	Stainless steel
Built-in display	Yes
Number of baskets	3 basket(s)
Custom panel-ready	-
Appliance placement	Fully built-in
AC input voltage	220-240 V
Energy efficiency scale	A to G
Water consumption per cycle	11 L
Energy consumption per cycle	0.85 kWh
Cycle time	175 min
Noise level	44 dB
Delay start (max)	24 h
Dishwashing programs	60min, Auto, Eco, Hygiene, Intensive
Number of place settings	16 place settings
Number of washing programs	6
Maximum hot water supply temperature	40 °C
Package depth	665 mm
Package width	640 mm
Package height	880 mm
Package weight	33500 g

Weight and Dimensions

Depth	555 mm
Width	598 mm
Height	816 mm
Weight	31500 g
Installation compartment width	600 mm
Installation compartment height (min)	820 mm