GDS3710 User Manual
Version 1.0.7.8
Figure 56: Card Info
Table 9: Card Info
Configures the username to identify the user.
Specifies a specific password to unlock the door.
Selects a gender, either Male or Female.
Enters an ID number (This number is set by the admin to identify each user
uniquely).
Enters the RFID Card number (this is the number written on the RFID card.
When “card issuing mode” is enabled, this filed will be added automatically.
Configures the start date of validity of the RFID card.
Configures the End date of validity of the RFID card.
When dialing directly from the keypad, the GDS accept only Virtual number
to identify a user, once the Virtual number is typed followed by # key, the
SIP Number will be dialed.
Configures the SIP Number which is mapped with virtual number. Once the
virtual number is dialed the GDS3710 will send an INVITE to the SIP
Number.
Note: The SIP Number can be configured with an extension/phone number
or IP address. Example: 192.168.5.124